-
In preparation for the second wave of my True-Tiles printing, I have been batch printing a lot of bases, while I wait for the little round magnets to arrive today. I believe I will need more square bases to fully re-finish the prior tiles, but I will be doing those once I have fully tested […]
-
I continue to produce the True-Tiles terrain, and although I have changed directions on the base pieces, the top pieces are just fine. However, after my first batch, I realized that using Army Painter paints for the painting of this amount was not very cost effective – I nearly emptied my Dark Wash bottle, and […]
-
—
by
I doubt I had anyone actually bother to watch my 3d printer in action, and if you had, then you likely found that the performance was certainly lacking. As an alternative, I have now instead configured it to run through my YouTube Live channel, with a streaming option instead. This provides far better quality, which […]
-
—
by
With the acquisition of the 3d Printer, my son’s big ask was for a prop for use during our gaming sessions. Since he is currently playing a Necromancer in our Pathfinder campaign, he of course wanted a skull to show off. And since I am always up for a challenge, we opted for not just […]
-
Finished up a second batch of tiles on the printer while I was out of town this week, then upgraded the little Raspberry Pi computer that manages the printer itself. Now I should have sufficient space to at least do a timelapse of future prints, and potentially even stream live to YouTube. Still a bit […]
-
Managed to take time to paint up the first set of True-Tiles, consisting of 10 doors, 4 flat tiles, 5 single wall tiles and 5 corner tiles. Total time, about 4 hours.
-
Are you mesmerized by an active 3D printer like I am? Can you stare for hours watching the robotic arm move back and forth as it slowly builds a model millimeter by millimeter? If so, then I have a fun little new option with my printer – a live feed that runs pretty much all […]
-
Finished printing a first batch of True-Tiles from the demo set, and my project this week is to paint and drybrush them this week, so they are ready for our next Pathfinder game. Set includes 5 corners, 5 single-wall sections, 4 field tiles, and 10 doors, which gives a decent start. From here, I need […]
Disclaimers and Legalese
This website uses trademarks and/or copyrights owned by Paizo Inc., which are used under Paizo’s Community Use Policy. We are expressly prohibited from charging you to use or access this content. This website is not published, endorsed, or specifically approved by Paizo Inc. For more information about Paizo’s Community Use Policy, please visit paizo.com/communityuse. For more information about Paizo Inc. and Paizo products, please visit Paizo.com.