• Success over the weekend, with the conclusion of Chapter 5 of the Rise of the Runelords.  The group, rather focused this week, managed to wrap up the Halls of Wrath section of Runeforge, and escape back to Golarion.  In the process, they rather easily defeated the guardians, and it was only when the Barbarian opted […]

  • You may have noticed, I have altered the timing for my daily posts.  Originally, I was posting on weekdays, and scheduling for 5 PM EST each day.  That worked, but in truth really encouraged me to create the posting at the last minute.  Since I have been trying to pre-schedule content as much as possible, […]

  • Several months ago, I posted about my project to craft and create a trophy for our annual Magic the Gathering tournament.  I managed to revisit this project this week, while I was spending time for work in Toledo.  Didn’t end up having as much time as I had hoped (we had a big outage to […]

  • Now that we had a chance to try the basic scenario of Star Wars: X-Wing, I have been eager to expand the collection.  However, I am making a point of only acquiring 2nd edition kits, mainly so I don’t have to deal with the conversion sets.  There are very few currently available, which helps the […]

  • We did plan on having our Pathfinder session this last weekend, to resolve the mystery of the fate of the group following the cliffhanger of the prior session.  Unfortunately, my son’s football game got rained out on Saturday, and rescheduled for Sunday, right in the middle of our usual schedule (and several of our players […]

  • Finally managed a successful casting in resin, though I am strongly debating whether it is a practical option or not.  Between the cost of molding and the resin itself, and then the cleanup after, it isn’t a very practical solution for this type of item.  In truth, that is no doubt why CNC wood cutting […]

  • As I continue to experiment and attempt resin molding, and fiddle and tune the 3d printer, I managed to finish a single full usable dice box, in my preferred copper PLA filament.  Its not the ideal design (I have a version with a Runelord’s Sihedron Rune in the top), but the lid and base are […]

  • Apparently, I made a mistake with the resin.  After a bit of math, I had estimated fairly closely the amount of resin mix required to fill the mold – right at 1 cup total.  Mix the material, add coloring, stir for several minutes, slowly pour into the mold.  After several minutes of slow pouring, I […]

Disclaimers and Legalese

This website uses trademarks and/or copyrights owned by Paizo Inc., which are used under Paizo’s Community Use Policy. We are expressly prohibited from charging you to use or access this content. This website is not published, endorsed, or specifically approved by Paizo Inc. For more information about Paizo’s Community Use Policy, please visit paizo.com/communityuse. For more information about Paizo Inc. and Paizo products, please visit Paizo.com.